Issue
- Oven clock flashes
- Oven clock displays "0:00" or "12:00" and flashes
- How to set the oven clock?
Applies to
- integrated oven
- freestanding cooker
Resolution
Flashing "0:00" on the clock’s display may be caused by an earlier power failure in the socket to which the oven is connected to. You need to set the oven clock again.
The clock setting method may vary, depending on appliance user interface.
Consult your user manual for more information.
Touch control (without + and - on display)
1. Press 
until starts to flash 
2. Use the temperature dial to set the hour
3. Press 
to confirm, now minutes should be flashing 00
4. Use the temperature dial to set the minutes
5. Press to confirm 
Touch control (with + and - on display)
- flashes when you connect the oven to the electrical supply, when there was a power cut or when the timer is not set.
1. Press 
2. Use 
and 
to set the hour. Press 
4. Use and to set the minutes. Press 
3. After approximately 5 sec., the flashing stops and the display shows the time.
Button control (Older style)
1. Press 
until 
starts to flash
2. Use 
and 
to set the correct time
3. Leave for approximately 5 seconds and the time set itself
Updated Button display
1. Press 
until 
starts to flash
2. Use 
and 
to set the correct time
3. Leave for approximately 5 seconds and the time set itself
Free Standing Cookers
You must set the time before you operate the oven.
When you connect the appliance to the electrical supply or after a power cut, 
flashes. Press the 
or 
to set the correct time.
After approximately 5 seconds, the flashing stops and the display shows the time of day.
To change the time, press 
again and again until 
starts to flash.
If you found the following information helpful, please give us a thumbs up below. If this information did not resolve your question, all constructive feedback is welcome.
Cause
- Flashing "0:00" on the clock’s display may be caused by an earlier power failure in the socket to which the oven is connected to.
- New installation - the clock requires setting
